Odd signal system error

Use this forum if you need help using TSRE.
Post Reply
ebnertra000
Posts: 7
Joined: 16 Jan 2019, 17:47
I use a standard test route when I build signal systems, but for this system, whenever I attempt to load said route in TSRE, it crashes almost immediately. The log mentions something about signal files when it cuts off (presumably because it crashed), but I can't tell for sure what I should be looking for. The log and sigcfg/sigscr files are attached below
Attachments
NKP_Files.zip
(5.28 KiB) Downloaded 206 times

eugenR
Posts: 45
Joined: 18 Jan 2019, 18:44
ebnertra000 wrote:
04 Mar 2021, 15:51
I use a standard test route when I build signal systems, but for this system, whenever I attempt to load said route in TSRE, it crashes almost immediately. The log mentions something about signal files when it cuts off (presumably because it crashed), but I can't tell for sure what I should be looking for. The log and sigcfg/sigscr files are attached below
Principally you have OR-Special Signal Functions in the signalfile, I am not sure if TSRE5 can deal with all this new OR-Signal-Functions.
But in your case it seams to work:
I have load your Signalfiles in the main-directory of my testroute (some 100m strait track, no signals) and load it in TSRE5.
It had normally started and I could place Signals, without to have the corresponding shapes in the shape-folder!
No Error, no crash.

Perhaps the problem is in your testroute?

Regards,
EugenR

Post Reply